Skip to content

What size is the oil drain plug on a 2008 toyota tacoma?

Notes: AutoGrade – oil-tite, M12 x 1.25 Thread size. SAE/Metric 14 mm Head size. 0.472″ Shank Length.

What is the size for a Toyota Tacoma drain plug?

Dorman – Autograde – Oil Drain Plug Standard M12-1.25, Head Size 14mm (Part No. 090-038CD)

What size is the oil drain plug on a 2008?

Dorman – Autograde – Oil Drain Plug Pilot Point M14-1.50, Head Size 16mm (Part No.

What size socket is my oil drain plug?

Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine. Make sure to place a bucket and some newspaper under the car’s engine to catch all the draining oil.

What size is the oil drain plug bolt?

Oil Drain Plug Standard M14-1.50, Head Size 17mm.

Where is the oil drain plug 2007 Toyota Tacoma?

The plug is located underneath the front of the truck on the bottom of the engine crank case. Warm up the engine by letting it run or driving it for 10-20 minutes to ensure the oil will flow easily.

How much oil does a 4.0 Tacoma take?

Capacity: 4WD, With filter 5.5 quartsAfter refill check oil level.

How much oil does a 2008 Focus take?

Motor oil — SAE 5W-20 motor oil. (Note that factory fill is 5W-20 synthetic blend motor oil, but that synthetic blend is not required.) Capacity is 4.5 quarts (4.3 liters).

What size is the oil drain plug on a 2008 Ford Focus?

Dorman – Help – Oil Drain Plug Pilot Point M14-1.50, Head Size 16mm (Part No. 69010)

How much oil does a 2008 Honda Accord take?

Capacity: Without filter 4.2 quartsAfter refill check oil level. With filter 4.4 quartsAfter refill check oil level.

How do I know what size drain plug I have?

Measure Diameter

Measure the width of the plug at the widest part of the threads. If your plug measures 12mm you will need to start looking at plugs in the size range of “M12 x 1.25 to M12 x 1.75″. The “M12” refers to the diameter you measure from the widest part of the threads on your OEM sump plug.

What is the socket size?

Metric Socket Sizes Chart

3/8″ Drive 1/4″ Drive 1/2″ Drive
7mm 5mm 10mm
8mm 5.5mm 11mm
9mm 6mm 12mm
10mm 7mm 13mm

Are drain plugs universal?

This plug is universal. It should fir on any oil pan. The only thing about it is that it is intended to be permanent. In other words, you don’t want to unscrew it too often to replace the oil.

Are oil drain plugs reverse threaded?

it is regular-threaded. Righty tighty. Also, as the plug is threaded into aluminum, I like to use a torque wrench on mine so as not to over tighten. Proper torque for the drain plug is 18 lb/ft.

How do you remove an oil drain plug?

You’ll need to spray penetrating oil on the oil plug and leave it to sit for several hours. Then you can take a small hammer and tap counterclockwise to ensure that you are loosening the plug.

What size wrench do you need to change oil filter?

If you have an SUV, pickup truck, or other big vehicles, a strap wrench is useful because the oil filters tend to be larger (up to 6 inches in diameter). You’ll need a 1/2-inch square drive tool to turn the bar that tightens the strap that firmly holds the filter.

What type of oil does a 2008 Toyota Tacoma take?

STP Engine Oil High Mileage Full Synthetic 5W-30 1 Quart

5W-30.

How do you change the oil on a 2008 Toyota Tacoma?

STP Engine Oil High Mileage Full Synthetic 5W-30 1 Quart

5W-30.

What kind of oil does a 2009 Toyota Tacoma take?

Mobil 1 – High Mileage 5W-20 Full Synthetic Motor Oil, 5 Quart (Part No. 120768)

How much oil does a 2008 Toyota Tacoma take?

Capacity: 4WD, With filter 5.5 quartsAfter refill check oil level.

What kind of oil does a 2007 Toyota Tacoma take?

Notes: Full Synthetic High Mileage. 5W-30.

What kind of oil does a Tacoma 4.0 take?

5W-30 is the best choice for good fuel economy and starting in cold weather. If 5W-30 is not available 10W-30 may be used. However, it must be replaced with 5W-30 at the next oil change.

What transmission is in 2008 Ford Focus?

5W-30 is the best choice for good fuel economy and starting in cold weather. If 5W-30 is not available 10W-30 may be used. However, it must be replaced with 5W-30 at the next oil change.

What kind of antifreeze does a 2008 Ford Focus use?

Zerex Antifreeze/Coolant G-05 Formula CONCENTRATE *5 Year/150K Mile Protection* 1 Gallon.

What kind of antifreeze does a 2008 Ford Focus take?

Zerex 1 Gallon Yellow 50/50 Coolant/Antifreeze.

What size is the oil drain plug on a Ford?

Dorman – Autograde – Oil Drain Plug Standard M14-1.50, Head Size 17mm (Part No.

What size is the oil drain plug on a 2010 Ford Focus?

Dorman – Autograde – Oil Drain Plug Pilot Point M14-1.50, Head Size 13mm (Part No. 090-938CD)

Where is the oil drain plug on a Ford Focus?

2 Answers. The oil drain plug is near the engine block, with the filter right nearby.