Skip to content

How much is an ignition coil for a 2007 toyota sienna?

We currently carry 4 Ignition Coil products to choose from for your 2007 Toyota Sienna, and our inventory prices range from as little as $88.52 up to $122.99.

How much is an ignition coil for a Toyota Sienna?

The average cost for a Toyota Sienna ignition coil replacement is between $331 and $445. Labor costs are estimated between $160 and $202 while parts are priced between $172 and $244. This range does not include taxes and fees, and does not factor in your specific model year or unique location.

How do you know if your ignition coil is going out?

Hard Starts and Stalling

If an ignition coil is malfunctioning and not delivering the required voltage to the spark plugs, you will find it hard to start the engine. If your vehicle stalls when you stop and even shut off completely, it could be a bad ignition coil sending irregular sparks to the spark plugs.

What is a ignition coil and how much does it cost?

On more modern cars, individual coils that feed one spark plug may only cost around $60 to $80 with installation ranging from $20 to $300 depending upon the location. A coil that is on the top part of the motor or on the side facing the radiator might be very simple to replace.

How long do Toyota ignition coils last?

Most ignition coils will last a minimum of 150K-180K miles before giving any issues, and typically longer if spark plugs were changed on schedule (worn spark plugs will wear down the ignition coil).

How much does it cost to fix ignition coil?

The average cost for ignition coil replacement is between $209 and $278. Labor costs are estimated between $51 and $64 while parts are priced between $158 and $214. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

How long does it take to replace ignition coil?

A change of an ignition coil pack can take several seconds. In most four-cylinder cars, it will take no more than one hour for your coil pack to be replaced. A larger engine will require more work and could have other components removed as well.

What causes an ignition coil to go bad?

Ignition coils tend to fail because of bad spark plugs or plug wires. If your vehicle’s fuel-to-oxygen mixture is either rich or lean, therefore, your ignition coils may fail prematurely. Additionally, engine heat and vibrations can cause damage to ignition coils.

How much do coil packs usually cost?

But in general, a set of coil packs will set you back around $150 – $300. Add labor cost of around $100 – $150 to the equation and the service bill can be as high as $450 for a coil pack replacement. Of course, some cars may cost more than this.

Are ignition coils expensive?

The cost of a single ignition coil averages about $20 to $40. The labor cost depends on the car model but will usually set you back around $50 to $100.

Do ignition coils need to be replaced?

While ignition coils do not have a service interval, they do have a lifespan. There is no specific mileage or age to replace them. They should only be replaced when they are bad. If you notice any cracks on the plastic or epoxy, and of course misfires, then it is time to replace the ignition coils.

Should I replace ignition coils with spark plugs?

So, should you replace coil packs with spark plugs? It depends. The most common component to replace in conjunction with the ignition coils are the spark plugs. Worn spark plugs can cause unnecessary load on the coils and there is often some overlap in the labor required to replace both components.

Is an ignition coil the same as a spark plug?

An ignition coil is an induction coil found in your car’s ignition system. Your car’s ignition coil transforms the battery’s low voltage into thousands of volts. In doing so, the coil creates an electric spark in the spark plugs. Here, the plugs ignite fuel.

How long do cheap ignition coils last?

You can replace the ignition coils every three to five years. However, you may also require replacement before that if the coil is bad earlier. Some ignition coils also last more than five years. Hence, you may not need to replace the coils for a long time.

Can you replace ignition coils yourself?

You can replace a failing ignition coil fairly easily at home, but remember that you’re dealing with high voltages so must disconnect your battery before you start.

Are cheap ignition coils any good?

While low-grade coils cause misfiring and difficult starting, using them can have more serious consequences. As coils are controlled by the engine management computer (ECU) they rely on fly-back voltages that are fed back after the spark plug has been ‘fired.

How long does it take to replace ignition coil and spark plugs?

Introduction. Changing spark plugs takes about an hour (for a four-cylinder engine) and will save you at least a hundred bucks in labor if you do it yourself. In most cases it’s a simple job that will help to maintain peak performance and the highest possible gas mileage.

How do you change ignition coils?

How to Change Ignition Coils

  1. Safety First. Ensure the engine is cool, apply the emergency brake, and open the hood. …
  2. Remove the Ignition Coils. Ignition coil replacement can be challenging on some vehicle’s engines. …
  3. Test Each Ignition Coil with a Multimeter. …
  4. Lubricate the Coils Install Them. …
  5. Check Your Work.

How long does it take to replace ignition switch?

Usually, an ignition switch replacement will only take about 20 minutes. However, it could take much longer depending on your car’s make and model and the complexity of the ignition covers.

Can I drive with a bad ignition coil?

A faulty Coil On Plug (COP) can be used to drive, but not in a safe manner. It is impossible to drive with a faulty waste spark ignition system. If you drive with a faulty coil pack, you can damage other engine components. In addition, you’ll learn how to diagnose and replace the faulty coil with a new one.

What is the code for a bad ignition coil?

Code P0351 is defined as “Ignition Coil ‘A’ Primary/Secondary Circuit Malfunction.” It’s an OBD-II diagnostic trouble code (DTC) that indicates a fault with ignition coil ‘A’ (a problem with the coil on cylinder #1 or its circuit).

What do bad coils sound like?

Engine misfiring will be seen in a vehicle whose ignition coils have failed. Trying to start the engine of such a vehicle will result in engine misfiring that sounds like a coughing, sputtering noise. When driving at high speeds, jerking and spitting will be seen in the behavior of the vehicle.