Skip to content

How much is a water pump for a 2004 jeep?

The more your engine needs to be disassembled to access the water pump, the higher the labor costs. Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor).

How much does it cost to replace a water pump in a 2004 Jeep Grand Cherokee?

The average cost for a Jeep Grand Cherokee water pump replacement is between $642 and $834. Labor costs are estimated between $202 and $255 while parts are priced between $440 and $579.

How much does it cost to replace a water pump in a Jeep?

The Best in Auto Repair

The average cost for a Jeep Wrangler water pump replacement is between $565 and $663. Labor costs are estimated between $142 and $179 while parts are priced between $423 and $484. This range does not include taxes and fees, and does not factor in your specific model year or unique location.

How much is a replacement water pump?

The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314. Estimate doesn’t include fees and taxes.

How long should a jeep water pump last?

The service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak. That’s why you should recommend a top-quality replacement water pump if a customer’s old water pump has called it quits.

How do you change a water pump on a 2004 Jeep Grand Cherokee?

The service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak. That’s why you should recommend a top-quality replacement water pump if a customer’s old water pump has called it quits.

How much is a water pump for Grand Cherokee?

The service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak. That’s why you should recommend a top-quality replacement water pump if a customer’s old water pump has called it quits.

How much is a water pump for a 2005 Jeep Wrangler?

The more your engine needs to be disassembled to access the water pump, the higher the labor costs. Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor).

How do you change a water pump on a Jeep Wrangler?

The more your engine needs to be disassembled to access the water pump, the higher the labor costs. Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor).

Is it worth replacing water pump?

About Water Pump Replacement

The water pump is an essential component that keeps the coolant circulating, a critical role in ensuring that the engine maintains the proper operating temperature. Without coolant being circulated, the engine will overheat, leading to premature wear and damage.

How do I know if my water pump is broken?

Five Signs Your Water Pump Is Failing

  1. Overheating. A dead or dying water pump cannot circulate coolant through your vehicle’s engine and, as such, the engine will overheat. …
  2. Coolant Leaks. Coolant leaks from the water pump are common and a clear sign that it’s time to replace the pump. …
  3. Corroded Water Pump. …
  4. Whining Noises.

How long does it take a mechanic to replace a water pump?

On average, water pump replacement is a 3 hour job. You may pay less if you buy the pump yourself and give it to the mechanic to install, though use caution and make sure to buy the parts from a reputable source.

How long will a water pump last after it starts leaking?

How Long Will Water Pump Last If Leaking? Keeping them in good working order they normally last 60,000 to 90,000 miles. Some cheaper water pumps have an estimate of 30,000 miles or less. It is important that you regularly clean the coolant on your water pump if you want to keep it in good working order.

Do water pumps wear out?

A worn out belt can prevent your water pump from operating at peak efficiency. Internally, there is an impeller that keeps the system circulating. Over time the impeller can actually wear down due to contaminants in the coolant. Cavitation can also cause the impeller to erode and lose the ability to pump coolant.

Why do water pumps fail?

Using a contaminated, incompatible coolant or mixing different formulations leads to premature water pump failure. Contaminants (e.g. abrasive particles and engine oil) scratch the internal mechanical seal or affect the pump’s wear resistance.

Where is the water pump located on a 2004 Jeep Grand Cherokee Laredo?

Using a contaminated, incompatible coolant or mixing different formulations leads to premature water pump failure. Contaminants (e.g. abrasive particles and engine oil) scratch the internal mechanical seal or affect the pump’s wear resistance.

Where is the thermostat on 2004 Jeep Grand Cherokee?

Using a contaminated, incompatible coolant or mixing different formulations leads to premature water pump failure. Contaminants (e.g. abrasive particles and engine oil) scratch the internal mechanical seal or affect the pump’s wear resistance.

How do you change a thermostat on a 2004 Jeep Cherokee?

  1. Step 1 – Drain the coolant. Open the hood, open the radiator cap on top of the radiator, and locate the drain plug on the bottom of the radiator on the passenger’s side. …
  2. Step 2 – Remove the thermostat. Locate the upper radiator hose. …
  3. Step 3 – Install the new thermostat. …
  4. Step 4 – Refill radiator.

How much is a water pump 2014 Grand Cherokee?

Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor).

How much is a water pump for a 2012 Jeep Wrangler?

The more your engine needs to be disassembled to access the water pump, the higher the labor costs. Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor).

How tight should a serpentine belt be on a Jeep Wrangler?

The required measure of tension in the serpentine belt is that it should not deflect more than ½ inch when twisted either way from the middle. If twisted more, the belt is loose, and if twisted less, the belt is too tight.

How do you change a water pump on a 2005 Jeep Wrangler?

The required measure of tension in the serpentine belt is that it should not deflect more than ½ inch when twisted either way from the middle. If twisted more, the belt is loose, and if twisted less, the belt is too tight.

How do you put a water pump?

The required measure of tension in the serpentine belt is that it should not deflect more than ½ inch when twisted either way from the middle. If twisted more, the belt is loose, and if twisted less, the belt is too tight.