Our 2004 Jeep Liberty Brake Rotors products start for as little as $57.21.
How much are rotors for a Jeep Liberty?
Our Brake Rotors OEM and aftermarket parts range from $57.21 to $91.46 for the Jeep Liberty.
How much should replacing brake rotors cost?
How much does it cost to replace the brake pads and rotors? Rotors cost between $30 and $75 each. Labor to replace rotors and pads is around $150 to $200 per axle. Brake pads and rotors come out to around $250 to $500 per axle.
How much do brakes and rotors cost on Jeep?
Brake pads for a Jeep can rate anywhere between $150 per axle and $450 per axle depending on the type of brake pad desired. Jeep Brake rotor replacement can rate anywhere between $300 – $750 for each four rotors to be replaced. This price value includes labor and elements.
Are rotors worth replacing?
Normally both rotors need to be replaced because they will usually have the same amount of wear. Even if one side is “good enough” it is wise to replace both brake rotors at the same time to maintain even braking as any difference in rotor thickness will cause the brakes to pull to one side.
Should I replace all 4 rotors?
You do not need to replace all 4 rotors at the same time, but it is recommended to replace the rotors and pads as a set for each axle front or back at the same time. If the front brakes need to be replaced but the rear brakes are not worn out yet, then you do not need to replace the rear brakes.
How do I know when my rotors are bad?
How to Tell if Rotor Is Bad (15 Bad Rotor Symptoms)
- Vibration in the steering wheel.
- Pulsating brake pedal.
- Intermittent brake noises.
- Grinding when hitting brakes.
- Screeching after brake pad installation.
- Out-of-round rotors.
- Deep grooves or score marks.
- Cracked rotors.
How much does it cost to turn rotors at AutoZone?
AutoZone can charge up to $25 per rotor for this service but often suggest a total replacement citing cost-effectiveness.
How much are disc rotors?
Rotors cost between $30 and $75 each. Higher-quality rotors like Duralast Gold, which feature a coated hat and edge and are designed to outperform your vehicle’s original equipment, usually cost a little more. Labor at a shop to replace rotors and pads is approximately $150 to $200 per axle.
How much is a brake job on a Jeep?
Jeep Wrangler brake pads replacement, which includes parts and labor, can cost anywhere between $150 and $300 per axle depending on the type of brake pads desired and the extent of the damage your previously worn down pads have caused to the other components of your vehicle such as the rotors.
How much does it cost to fix brakes on a Jeep?
The Best in Auto Repair
The average cost for a Jeep Wrangler brake pad replacement is between $268 and $285. Labor costs are estimated between $65 and $82 while parts are priced at $203. This range does not include taxes and fees, and does not factor in your specific model year or unique location.
Can I put new brake pads on old rotors?
When properly bedded and used over time, a thin layer of brake pad material is transferred to the brake rotor surface, and this helps create optimal friction for stopping. When a set of pads is worn out and need to be replaced, it is perfectly ok to install a new set of pads on the old rotors.
How many miles do rotors last?
As a general rule, you should get your brake pads replaced every 10,000 to 20,000 miles to keep wear to a minimum. When it comes to your rotors, you have a bit longer. Your rotors should be replaced between 50,000 and 70,000 miles to keep your brakes in peak health.
How often do you replace brake rotors?
So how often do brake rotors need to be replaced? They should be replaced about every 70,000 miles on most vehicles. Of course, this may vary depending on your style of driving, the weight of your vehicle, the quality of the braking components, and the use of your vehicle.
How do you tell if you need new rotors?
Here are 7 Signs your brake rotors need replacing:
- Your rotors are blue.
- Grooves or scoring on the rotors.
- A squeaking or screeching sound.
- The car takes too long to break.
- Your car starts to vibrate during brakes.
- Your ABS system gives you warnings.
- Your car service professional recommends new rotors.
Can I replace only one brake rotor?
There is no problem at all replacing a single rotor. They are sold individually, and can be replaced as such. It is especially important to bed in the pads if you do this, but once the pads conform to the rotors, the stopping power on each side will be the same. There can be major problems replacing pads individually.
How do you know if you need front or rear rotors?
If the rotor has hot spots, cracks, or ridges, replace it even if the width is thicker than the discard measurement. Replace brake rotors based on the wear and condition of each rotor. Unless there is damage from road debris or worn-out brake pads, rear rotors should last two or three times longer than front rotors.
Can you drive with bad rotors?
If you suspect you have warped rotors or your brakes are failing, it is important that you avoid driving your vehicle and contact a mechanic right away. Driving with warped rotors potentially will result in a brake system failure, which can cause injury to yourself and those around you.
What do bad brake rotors sound like?
Noises When the Vehicle Brakes
Warped rotors can cause a squeaking noise when the brakes are applied. They can also make a scraping or grinding sound when they’re warped and worn down. The squealing noise, however, can also be made by brake pads that are worn out.
Does O’Reilly turn rotors?
Drum &, Rotor Resurfacing
Not only do we carry the best replacement brake system parts, including pads, rotors, calipers, and more, we can also resurface brake rotors and drums for a small fee at most of our locations.
How much do brakes and rotors cost at Firestone?
Firestone brake replacement costs range from $350 to $470, including parts and labor on new pads and rotors.
…
Firestone Cost and Service Breakdown.
| Brake Pads | Brake Pads &, Rotors |
|---|---|
| $130-$240 per axle (includes rotor resurfacing) | $345-$398 per axle |