Skip to content

How much is a cv axle for a ford focus?

An AWD car will have the same, but additionally two in the rear of the car.

Car 2018 Ford FocusL3-1.0L Turbo
Service Service typeAxle / CV Shaft Assembly – Driver Side Front Replacement
Estimate Estimate$568.87
Shop/Dealer Price Shop/Dealer Price$693.24 – $1037.04

How much does it cost to replace an axle on a Ford Focus?

The average cost for a Ford Focus axle shaft seal replacement is between $190 and $224. Labor costs are estimated between $132 and $167 while parts are priced at $58.

How much should it cost to replace a CV axle?

The average cost for CV axle replacement is between $941 and $1,070. Labor costs are estimated between $136 and $172 while parts are priced between $805 and $899. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

How serious is a CV axle?

If the boot that seals the CV joint is damaged, the grease will leak out and contamination will set in, eventually causing the joint to wear out and fail. A severely worn out CV joint can even disintegrate while you’re driving and make the car undrivable. You may lose control of the vehicle entirely.

Can you drive with no CV axle?

Yes you can drive your truck with out cv joints. But you do need part of the cv joint . If that makes any sence. If you break a cv joint pull it apart and remove the joint of the cv closes to the wheel.Be sure to remove the other parts of the cv joint not used.

How much is a CV shaft?

CV Axle Replacement Expenses

Replacement axle shafts can be bought for between $60-150.00 each, and labor is generally between 1.5-3 hours to replace, bringing labor to around $150-350.00.

How do you test a CV joint?

Take a Test Drive

  1. Put the car in reverse. Then turn the steering wheel all the way to one side and drive backward in a circle. Turn the steering wheel in the other direction and repeat the process.
  2. If you hear a very pronounced clicking or snapping noise, there’s a good chance an outer CV joint is worn out.

What causes CV axle to break?

Why do CV joints break? The main culprit is shock loading, like when a spinning wheel lifts off the ground and then lands hard, something that can happen fairly often with an independent suspension system because of the usually limited amount of travel.

How long does it take to replace a CV axle?

Replacing a CV axle is a maintenance item that usually takes between one and a half to three hours to complete, depending on the vehicle and if other repairs are needed. A CV axle typically lasts for 70,000 to 130,000 miles, but the axles should be inspected for damage regularly.

How much does wheel axle cost?

On average, you can expect it to cost between $880 and $959 to replace your car axle shaft, depending on the type of car you drive and which axle is broken.

How long can you drive with a broken CV axle?

It could take weeks, months, or years. But the average lifespan of a bad CV axle is around five to six months. Knowing this does not merely mean to stretch the deadline a little bit. You might be thinking that you can save more money by postponing the checkup for your ATV/UTV.

Should you replace both CV axles at the same time?

On a high-mileage vehicle with a bad CV joint or boot, it’s often a good idea to replace both shafts at the same time. Often, the right (passenger side) shaft fails first because right turns are at a sharper angle than left turns, and right turns are more common than left turns.

What happens if your CV axle breaks while driving?

If a CV joint begins to fail while driving, your car will start to pull to one side as one wheel loses power. When the joint breaks completely its corresponding wheel will no longer turn and although the engine may still run, the car won’t move.

How do you know if your CV axle is going out?

Below are the four most common symptoms of a bad CV axle, if you notice any of these, head to your local Chevrolet service center immediately.

  1. “Clicking” Noises When Turning.
  2. A Knocking Sound. …
  3. Grease on the Inside or Edge of the Tires. …
  4. Vibration While Driving. …

Can you push a car with a broken axle?

Moving a car with a broken axle is tricky, but you still have options. While you can attempt to push your car, it is safer to call a tow truck for assistance. The reason why your vehicle is not moving is that when an axle is damaged while you are driving, more likely than not, one of your wheels will lose power.

Can you replace CV axle yourself?

You absolutely can replace your CV axle at home, but you’ll need to be at least remotely comfortable using a jack, jack stands, and power tools. Assuming you have most of the equipment already set up in your garage at home, the cost to replace your CV axle will be quite reasonable.

Can a CV axle be repaired?

Waiting until the CV Axle fails completely will result in a breakdown that can strand you miles from a repair facility. Fortunately, CV Axles are commonly available, and replacing them is not a major repair. A qualified repair facility can diagnose and replace a failing CV Axle in a timely manner.

Can a CV axle leak?

What Are the Signs of a Leaking CV Axle? A grease leak is the most common sign you’ll witness with a CV axle leaking. With extended use, wear, and tear, the CV boot can dry out which results in tears and cracks. Once that happens, the CV boot will allow grease to seep through inside the wheel.

Is CV joint same as CV axle?

A CV axle has two CV joints (an inner joint and an outer joint). These joints allow the axle to transfer the engine’s power to the drive wheels at a constant speed while accommodating for the different travel conditions, including the up and down motion of the suspension and cornering.

What does it sound like when your CV joint goes out?

Ans: The most common symptoms of a bad CV joint are the clicking, popping, and clunking sounds it makes when decelerating or accelerating. Vibration when driving is also a common symptom. You might find grease on the car’s underside caused by a torn boot leaky oil.

What happens when inner CV joint fails?

Inner CV joint failures are rare. One of the symptoms of a failed inner CV joint is lateral (side-to-side) shaking or vibration during acceleration. A worn-out inner CV joint may also cause clunking when shifting from Drive to Reverse or from accelerating to decelerating.

What broken axle sounds like?

When constant velocity axles fail, you may also hear an unusual clicking sound may when turning the vehicle as joints become loose. These clicks are on the side of the faulty axle shaft and typically become noisier during sharp or fast turns.

What makes an axle go bad?

Things that can break your vehicle’s axle include poor maintenance, an auto accident, hitting curbs, potholes, or bumps too hard, and overloading your vehicle beyond its weight-bearing capacity. The axle is responsible for transferring the engine’s power and transmission’s torque to the wheels.

What are the symptoms of a broken axle?

Top 6 Signs of a Damaged or Broken Car Axle

  1. Leaking.
  2. Brake Pad Misalignment. …
  3. Wheel Wobbling &amp, Vibrations. …
  4. 4. “ …
  5. Vehicle Strains. Car axles are fairly resilient, but when they’re under pressure, you’ll feel it in the gas pedal. …
  6. Car Won’t Budge. The most obvious sign of a broken axle is when your car tires won’t rotate. …