Skip to content

How much does it cost to fix ac in 2012 ford fusion?

Ford Fusion AC Compressor Replacement Cost Estimate. The average cost for a Ford Fusion AC compressor replacement is between $831 and $1,157. Labor costs are estimated between $122 and $154 while parts are priced between $708 and $1,003.

How much does it cost to fix AC in a Ford Fusion?

On average, the cost for a Ford Fusion Car AC Repair is $249 with $116 for parts and $133 for labor. Prices may vary depending on your location.

Why is my AC not working in my Ford Fusion?

The most common reasons a Ford Fusion ac isn’t working are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor. You may not realize there’s a refrigerant leak until the air conditioner stops blowing cold.

Is AC expensive to fix in car?

Typically, depending on the severity of the issue, it can cost anywhere from $100 to $900 to fix a car’s air conditioner. Costs tend to run higher when you need to purchase additional parts, like a new compressor, condenser, sensor, or hose.

Why is my Ford Fusion not blowing cold air?

If your car’s air conditioning isn’t blowing cold air at all (or it tries, then turns warm), you could have a clogged expansion valve, a faulty compressor clutch, a leak, or a malfunctioning fuse in the system.

How much is a Ford Fusion AC compressor?

The average cost for a Ford Fusion AC compressor replacement is between $831 and $1,157. Labor costs are estimated between $122 and $154 while parts are priced between $708 and $1,003. This range does not include taxes and fees, and does not factor in your specific model year or unique location.

Where is AC condenser located in Ford Fusion?

The condenser has the important job of removing heat from the refrigerant circulating throughout the system, thereby converting the refrigerant from a vapor to a liquid. You’ll find it located behind your car’s grille, in front of the radiator.

Why is my 2012 Ford Fusion AC not working?

The most common causes that hinders normal operation of air conditioning system on your Ford Fusion are dirty cabin air filter, refrigerant leak, dirty or clogged condenser, dirty or clogged evaporator, bad blower motor, defective compressor, faulty blend door actuator or any fault in the electrical system.

How do you reset a Ford HVAC module?

With the doors closed locate the climate control power button on the center dash and depress it simultaneously with the Edge’s defrost button. Hold for a few seconds and release. Press the climate control power button one more time and the HVAC should be reset.

How do you turn on the AC in a 2010 Ford Fusion?

With the doors closed locate the climate control power button on the center dash and depress it simultaneously with the Edge’s defrost button. Hold for a few seconds and release. Press the climate control power button one more time and the HVAC should be reset.

How do I fix my car AC not blowing cold air?

The most common cause of a vehicle’s air conditioner not getting cold enough is that it needs to be recharged. You can recharge your refrigerant by yourself, but to save time and make sure the job is done correctly you should make an appointment with your local professional auto shop.

Will AutoZone recharge my AC?

AutoZone does not recharge AC systems in vehicles. However, the company has all the tools and products in stock, including oils, refrigerants, system cleaners, and stop leaks that you can use to recharge your AC by yourself.

How much does it cost to recharge car AC?

The Average Cost to Recharge Your Car Air Conditioner Is $20 to $155, Depending on if You Go to the Mechanic or DIY. This price range is based on national averages for all vehicles and does not factor in taxes, fees, or your particular make and model.

Where is the blend door actuator on a 2011 Ford Fusion?

All blend doors are behind the dash. There are 2 blend doors for temperature on a Fusion, one behind the center stack on the left side of it for the driver’s side temperature mix, and on the right side of the stack behind the dash for the passenger side mix.

How do I reset my Ford Eatc?

To exit the self-test and clear all DTCs, press the DEFROST button. The vacuum fluorescent display window will show 888 and all function symbols for one second. Then, the EATC control assembly will turn OFF (display blank) and all DTCs will be cleared.

How do you reset the radio on a 2014 Ford Fusion?

To reset the system:

  1. Simultaneously press and hold the Seek up and the Audio Unit Power buttons until the screen goes black.
  2. Wait three minutes to allow the system to complete the reset.
  3. Press the audio unit power button to switch the system on.

What kind of Freon does a 2012 Ford Fusion take?

A/C Certified Pro R134a PAG 46 Refrigerant Oil with Ice 32 8oz.

How do you put Freon in a 2007 Ford Fusion?

A/C Certified Pro R134a PAG 46 Refrigerant Oil with Ice 32 8oz.

How do I reset my Ford climate control?

To reset the Ford Escape climate control: press the off and floor buttons together, press the auto button, and press the front defrost button. Being a sweaty mess is never a good time. That’s why the air conditioner needs to be in top shape.

How do I reset my climate control?

Here are the steps you need to take to reset your AC thermostat.

  1. Shut Down Your AC at the Thermostat. …
  2. Find Your Circuit Breaker Box. …
  3. Reset the Circuit Breaker for Your AC Unit. …
  4. Wait 30 Seconds. …
  5. Turn the AC Thermostat Back On. …
  6. Call Vredevoogd Heating &amp, Cooling for all your Furnace &amp, AC needs.

How do I reset my blend door actuator Ford?

To carry out calibration, carry out the following steps. Remove BCM fuse 46 for at least one minute. NOTE: When the ignition switch is switched to the ON position, the HVAC module will initialize and calibrate the actuators. Calibration of the actuators will take approximately 30 seconds.