Skip to content

How much do brakes cost for a ford fusion?

How much are brakes for a Ford Fusion?

The Best in Auto Repair

The average cost for a Ford Fusion brake pad replacement is between $205 and $227. Labor costs are estimated between $87 and $110 while parts are priced at $118. This range does not include taxes and fees, and does not factor in your specific model year or unique location.

How much does a full brake job usually cost?

Depending on the vehicle you drive, there can be a pretty big difference in pricing. The average brake pad replacement costs around $150 per axle, but these costs can rise to around $300 per axle depending on your vehicle’s brake pad materials. The least expensive brake pads use organic material.

How long do Ford Fusion brakes last?

Drum brakes

The rear brake has an average life of approximately 80,000 miles. It is recommended to have it checked every 30 thousand miles. Never do it by yourself. Always go to your trusted workshop or, better yet, to the nearest dealer.

How much does a brake job cost at Ford?

How much does a brake job cost? Brake pads for a Ford can cost anywhere between $150 per axle and $450 per axle depending on the type of brake pad desired.

How much do rotors cost for a 2010 Ford Fusion?

2010 Ford Fusion Brake Rotor – from $39.99+ | AutoZone.com.

Can Ford Fusion rotors be resurfaced?

Front brake rotors commonly will wear down faster than the rear rotors, and that is true for your 2020 Ford Fusion as well. Ford recommends getting your entire brake system inspected every 5,000 – 10,000 miles and changing out or resurfacing your rotors as needed.

How much does it cost to change all 4 brake pads?

How much does it cost to replace all 4 brake pads? To replace all four brake pads, including parts and labor the cost ranges between $230 and $600 for all four wheels. These materials range in quality from poor quality to premium.

How much should I pay someone to change my brakes?

You’ll also notice a parts mark up, although a solution here is to purchase your own parts and only pay a pro labor to install them. Labor rates can vary widely, but we’ll assign an average labor cost of $200, raising your total cost for a brake job closer to $350 to $500 at a repair shop.

When should you replace your brakes?

Brake Pads: When to Replace Them

As a general rule, you should get your brake pads replaced every 10,000 to 20,000 miles to keep wear to a minimum. When it comes to your rotors, you have a bit longer. Your rotors should be replaced between 50,000 and 70,000 miles to keep your brakes in peak health.

What are the worst years for Ford Fusion?

Since the car premiered in 2006, the Fusion has received two out of five for owner satisfaction for several model years, including the 2010 and 2011 model years. Other years that owners weren’t happy with are 2008, 2012, 2013, 2014, and 2016.

Are Ford Fusions reliable?

The Ford Fusion Reliability Rating is 4.0 out of 5.0, which ranks it 18th out of 24 for midsize cars. The average annual repair cost is $581 which means it has average ownership costs. The frequency and severity of repairs are both fairly average when compared with all other vehicles.

Are Ford Fusions good cars?

Yes, the 2020 Fusion is a good used sedan. It impresses with its comfortable cabin, intuitive infotainment system, gentle ride, and zesty handling. It also has a large trunk, low projected ownership costs, and one of the highest predicted reliability scores in the midsize car class .

How much does it cost to replace brake rotors and calipers?

You can expect to pay between $30 and $75 per rotor and between $150 and $200 for the labor for each axle, for a total of between $250 and $500 per axle. Calipers are the most expensive part of the brake system to replace. A single caliper can cost around $130.

What kind of brake pads does Ford use?

Ford Motorcraft® Brake Pads

Motorcraft® Brake Pads have been rigorously tested in your vehicle. Motorcraft® Brake Pads were developed specifically for your vehicle’s braking needs. Motorcraft® Brake Pads are made of the best materials and specifications for your Ford vehicle.

What make of brake pads do Ford use?

Genuine Motorcraft Brake Components

Motorcraft® brake and friction parts are the only ones designed, engineered and recommended specifically for Ford vehicles by Ford Motor Company. They’re built with the understanding that can only come from being the Original Equipment (O.E.) manufacturer.

How much is a brake caliper for a 2010 Ford Fusion?

We currently carry 3 Front Brake Caliper products to choose from for your 2010 Ford Fusion, and our inventory prices range from as little as $86.99 up to $88.37.

How do you change the rotors on a 2010 Ford Fusion?

We currently carry 3 Front Brake Caliper products to choose from for your 2010 Ford Fusion, and our inventory prices range from as little as $86.99 up to $88.37.