Skip to content

What is wrong with my dodge nitro if it isn’t blowing heater?

The most common reasons a Dodge Nitro heater isn’t working are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.

Why is my car heater not blowing any air?

If the heater isn’t blowing hot air at you when you turn the system on, the blower fan might have a problem. Either it’s not getting electrical power or, more likely, the motor itself has simply burned out. A blower motor in an older vehicle is likely to burn out over time, and may need replacement.

Why suddenly my heat doesnt work in my car?

A heater can stop working for a number of reasons, including: A low antifreeze/water level in the radiator due to a leak in the cooling system. A bad thermostat that isn’t allowing the engine to properly warm up. A blower fan that isn’t working properly.

What problems do Dodge Nitros have?

Top Dodge Nitro Problems

  • Engine Won’t Start. …
  • Defective Power Door Lock. …
  • Illuminated Liftgate Ajar Light. …
  • Loose Steering Wheel Emblems and Non-Deployment of Head Restraints. …
  • Defective Remote Keyless Entry System. …
  • Engine Stalling. …
  • Engine and Transmission Issues due to Outdated PCM Software. …
  • Stuck Rear Door.

What does it mean when your heater doesn’t work?

Dirty and clogged filters are one of the primary causes of furnace problems and can cause high operating costs. The heat exchanger can overheat and shut off quickly when filters are clogged with dust and dirt. This also causes soot buildup on the heat exchanger, which makes your furnace run less efficiently.

What would cause my heater blower to stop working?

If little air is coming through the vents (hot or cold), then it could be because the blower motor for the fan or a switch or resistor that controls fan speed isn’t working. Another cause might be that the electronically controlled “blend doors” that direct air flow are stuck or broken.

Can a fuse cause car heater not to work?

Faulty Wiring or Blown Fuses

Similar to your broken HVAC controls, your car’s wiring could be broken or have a short in it. This would mean the heater isn’t triggered when the driver commands it to function. Not good.

What do I do if my heater is blowing cold air?

If your furnace is blowing cold air in your home, this is a sign of an issue with the flame detector, gas supply, air filter, pilot light, or condensate lines. Many of these issues are able to be easily solved on your own by sanitizing or replacing components in the gas furnace.

How much does it cost to replace a blower motor?

Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.

How long do Dodge Nitros last?

On average, a Dodge Nitro lasts between 200,000 – 220,000 miles. 28,41% of Dodge Nitro’s on the road today have reached a mileage of 150,000 miles or higher. 54,61% of them have reached a mileage between 100,000 – 149,999 miles, and 16,98% have a mileage below 99,999 miles.

Do Dodge Nitros have a lot of problems?

Dodge Nitro Reliability Problems. Nitro owners have made 311 complaints over 5 model years. Using our PainRank™ system we’ve ranked it 18th in overall reliability out of 29 Dodge models , with real electrical and interior concerns.

How long does a Dodge Nitro transmission last?

But on average, we’ve seen the Dodge Nitro transmission last for between 130,000-180,000 miles. A high quality replacement transmission however, can last considerably longer if all of the factory design flaws have been addressed and the vehicle has been maintained.

Is there a fuse for the blower motor?

Many vehicles have two fuses for the blower motor, one in the interior fuse block and the other under the hood. The blower motor is usually under the dashboard on the passenger side.

Which fuse is for the heater blower?

Because of the volume of air that is moved by the blower fan, the motor may pull up to 20 amps or more at high speed. To protect the blower motor power circuit, a 20-, 25- or 30-amp fuse is usually located in the fuse panel under the dash.

Where is the blower motor reset button?

Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.

How do you know if your heater blower motor is bad?

What Are Signs Your Blower Motor Needs to Be Replaced?

  1. Poor or Airflow from Air Vents.
  2. No Airflow At All From Vents.
  3. Skyrocketing Energy Bills.
  4. Strange Noises When You Turn on the Heat.
  5. Overheating Blower / Weird Smells.

How do I reset my blower motor?

How to Find and Reset your Furnace Motor Blower

  1. Step 1: Turn off the power to the furnace. …
  2. Step 2: Remove the blower compartment cover. …
  3. Step 3: Make sure the blower is completely cooled off. …
  4. Step 4: Locate the reset button. …
  5. Step 5: Press the button in (assuming that this is your issue and that the button has popped).

How do I know if my heater fuse is blown?

You may also need to use your multimeter to check if your fuses are blown. You can quickly determine by checking resistance with a multimeter. A good fuse will have nearly zero ohms of resistance, if the fuse is blown there will be no reading.

Why is there cold air coming out of my vents?

Your Air Filter Is Dirty

Clogged air filters could be causing cold air to blow out of your vents. A dirty air filter can block airflow over your furnace’s heat exchanger, which can cause it to overheat.

Why is cold air coming out of my vents when the heat is off?

Cold air coming from vents when the heat is off is usually due to a simple setting on your thermostat. Generally, when this issue is happening, the “Fan” setting is set to “On” instead of “Auto.” What is this? When the fan is set to “On,” the furnace’s blower motor (fan) runs constantly.

Why does my heat feel like cold air?

Your Heat Pump May Be In Defrost Mode

As heat is released through the outdoor unit, it melts ice formations that would have been difficult or damaging to remove manually. Defrost mode is essentially the same as cooling mode, therefore it is likely your heat pump will blow cool air while in this mode.

What causes blower motor failure?

The main causes of failure are loss of lubricant, a failed run capacitor, a failed bearing in a belt drive, a little water dripping into the windings or a voltage problem. So technicians should carefully check to find the cause of a failure before changing the motor.

Is it hard to replace a blower motor?

If you don’t want to sweat or shiver, then find a good mechanic. The replacement of the blower motor is common and straightforward, so most shops will perform the repair — many on the same day.

How do I know if I need a blower motor or a resistor?

Here are some of the warning signs of a bad heater blower motor resistor: Fan does not work at all, so no air comes out of the vents. Fan only works on some speeds and not others. Fan only works on the highest speed.

How reliable are Dodge Nitros?

The Dodge Nitro Reliability Rating is 4.0 out of 5.0, which ranks it 8th out of 26 for midsize SUVs. The average annual repair cost is $582 which means it has average ownership costs. The severity of repairs is average and the frequency of those issues is low, so major repairs are uncommon for the Nitro.

Is a Dodge Nitro a Jeep?

The Dodge Nitro is a compact SUV manufactured and marketed by Dodge for model years 2007-2012 across a single generation — as a close variant of the second-generation Jeep Liberty.

Dodge Nitro
Platform Chrysler KA platform
Related Jeep Liberty Jeep Grand Cherokee Jeep Commander Jeep Wrangler
Powertrain

What kind of oil do you put in a 2007 Dodge Nitro?

Engine Oil

Viscosity: All TEMPS….5W-20
Capacity: With filter 5 quartsAfter refill check oil level.
Torque: Oil Drain Plug…25 ft/lbs

Are Dodge Nitro fast?

The Nitro accelerates promptly from 0 to 60 mph in just seconds. If you want to go fast, the Nitro has a top speed of miles per hour. Despite this excellent power train output, the Dodge Nitro’s fuel economy is rated at 16 miles per gallon in the city and 22 highway miles per gallon.

What are common problems with 2011 Dodge Nitro?

Top 2011 Dodge Nitro Problems

  • Engine May Not Start at Times. …
  • Power Door Lock Inop. …
  • Liftgate ajar switch issue. …
  • Remote Keyless Entry May Not Work at Times. …
  • PCM Software Update Available. …
  • Overhead Video Screen Does Not Power On. …
  • Coolant leak from reservoir. …
  • The Automatic Transmission may Stay in the Default Mode.

Does the Dodge Nitro have transmission problems?

It’s a type of car problem that’s not hard to notice. 2011 Dodge Nitro transmission problems could include shifting delays, jumping or grinding during acceleration, the car shaking at any speed, or a burning smell or whistling sounds coming from under the hood.

What kind of transmission is in a Dodge Nitro?

Three transmissions are offered on the Dodge Nitro: a six-speed manual, a four-speed automatic and a five-speed automatic. The six-speed manual transmission is standard on the Dodge Nitro SXT 4×2 and 4×4 models with the 3.7-liter V-6 engine. The transmission provides optimal shift quality and improved quietness.

How do you check the transmission fluid on a 2007 Dodge Nitro?

To check the levels of the nitro tranny you need to bring it to temperature and shift it into drive and reverse a couple times. Then you are supposed to cross reference a graph and level on a special dipstick.

Do they still make the Dodge Nitro?

The Dodge Nitro is a small SUV and is similar to the Jeep Liberty. Introduced in 2007, the five-passenger Nitro offered rear- and four-wheel configurations and two V6 engine choices. Dodge discontinued the Nitro in 2011, ending a five-year model run.

Where is the blower motor relay fuse located?

Under the instrument panel, look under the glove box. On the right side of the fender wall you will find another fuse box. The blower motor fuse is easy to replace.

How much is a blower motor fuse?

The average cost for blower motor relay replacement is between $73 and $83. Labor costs are estimated between $36 and $46 while parts are priced at $37.

How do I reset my heater?

The average cost for blower motor relay replacement is between $73 and $83. Labor costs are estimated between $36 and $46 while parts are priced at $37.

Where is the furnace reset switch?

Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.