What does the dash light with a lightning bolt mean?
The lightning bolt warning light alerts you to a fault in the electronic throttle control system in your vehicle. This may be a faulty throttle body, the throttle body sensor or possibly the throttle body control motor which is what controls the opening and closing of the throttle body as the motor requires more fuel.
How do you reset the red lightning bolt on a Dodge Caliber?
To reset the system all You need to do is turn on the vehicle without starting the engine. After that You can just press down on the throttle pedal for ten seconds and wait until the engine light starts to blink.
How do I fix my electronic throttle control light?
solution: stop driving your vehicle and have it towed to your mechanic. there, the first step will be to scan the engine computer for a trouble code. this should point your mechanic in the right direction. if there is no code, then a check of the sensors, relays, and wiring in the system should identify the problem.
What does red lightning bolt on Dodge mean?
The lightning bolt icon on your dashboard alerts you to a problem with the electronic throttle control system in your 2014 Dodge Charger. The gas pedal is not mechanically connected to the engine.
How much does it cost to fix electronic throttle control?
If it’s the electronic throttle controller then the replacement cost can range from $300 to $1,500 depending on the location and time to complete the job. If it’s the throttle body itself that is damaged and needs to be replaced, the costs can also be in the same neighborhood.
Can you drive with electronic throttle control light on?
It is not safe to drive with an electronic throttle control light. While you might be lucky and only have a drop in fuel efficiency or a slight drop in acceleration, the problem can quickly get worse if the sensor readings continue to go awry.
How do you reset a Dodge Caliber?
Dodge Caliber Oil Change Maintenance Service Indicator Warning Light Reset
- Close all doors. …
- Immediately Fully depress the GAS PEDAL slowly three times within 10 seconds Make sure to depress the pedal all the way down.
- Turn the ignition off and start the engine to verify the indicator has been reset.
What does a lightning bolt in parentheses Dodge?
This is the Electronic Throttle Control (ETC) Indicator symbol. This light, a lightning bolt between reversed brackets or parenthesis, will illuminate if there is a problem in the electronic throttle control system.
How do you reset throttle position sensor?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
Where is the electronic throttle control located?
The throttle controller is located on top of the engine between the air intake and the intake manifold.
Can I replace throttle body myself?
Disconnect any air or vacuum hoses from the throttle body. Remove the throttle position sensor from the throttle body. Remove the throttle body mounting screws and remove the throttle body assembly. Discard the old gasket and install a new gasket between the throttle body and manifold during installation.
How do you clean a throttle body without removing it?
Here is how to clean a throttle body without removing it.
- Get a clean towel and a throttle body cleaning product. …
- Get access to the throttle body. …
- Move the throttle plate to an open position. …
- Spray the throttle body cleaning product. …
- Clean the throttle body with a clean towel. …
- Reinstall the engine air intake rubber.
Is replacing a throttle expensive?
Throttle Body Replacement Cost
While the throttle body isn’t the most expensive component on your vehicle, it’s not exactly cheap either. If you do find that your vehicle needs a new throttle body, you can expect to spend anywhere between $450 and $600 on both parts and labor.
What does a electronic throttle control do?
Electronic throttle control facilitates the integration of features such as cruise control, traction control, stability control, and precrash systems and others that require torque management, since the throttle can be moved irrespective of the position of the driver’s accelerator pedal.
How do you turn off the change oil light on a Dodge Caliber?
Electronic throttle control facilitates the integration of features such as cruise control, traction control, stability control, and precrash systems and others that require torque management, since the throttle can be moved irrespective of the position of the driver’s accelerator pedal.
How do you turn off the check engine light on a Dodge Caliber?
You can turn your vehicle’s off key on and off to check the engine light. A reboot is necessary to restore the saved state of the computer. The key will start turning on and off for a few seconds, then start turning off again for 1-2 seconds. You can repeat this step three or four times.
How do you check the oil on a Dodge Caliber?
Doing a Dipstick Oil Check
Open your vehicle’s hood and look for a small loop or handle. Pull on the loop/handle and fully remove the dipstick from the engine. Take a heavy paper tower or a rah and wipe off all of the oil on the dipstick. Then put the dipstick back into the shaft and wait a moment.