Skip to content

How much is a throttle for a dodge avenger?

The average cost for a Dodge Avenger throttle body replacement is between $442 and $454. Labor costs are estimated between $47 and $59 while parts are priced at $395. This range does not include taxes and fees, and does not factor in your specific model year or unique location. Related repairs may also be needed.

How much does it cost to get throttle fixed?

The throttle body part will typically cost between $200 and $500, depending on the type of car that you drive. Labor costs for this kind of repair are typically relatively low, so you can expect to pay between $50 and $150 to have the part professionally installed.

How much is a throttle body for a dodge?

The average cost for a Dodge Ram 1500 throttle body replacement is between $323 and $457. Labor costs are estimated between $56 and $70 while parts are priced between $267 and $387.

How much does it cost to fix electronic throttle control?

If it’s the electronic throttle controller then the replacement cost can range from $300 to $1,500 depending on the location and time to complete the job. If it’s the throttle body itself that is damaged and needs to be replaced, the costs can also be in the same neighborhood.

What is a throttle malfunction?

A malfunctioning throttle position sensor will relay bad data to your car’s computer and usually result in poor fuel economy. Knowing the symptoms of a defective throttle position sensor can help you quickly diagnose the problem and make needed corrections.

Is replacing a throttle expensive?

Throttle Body Replacement Cost

While the throttle body isn’t the most expensive component on your vehicle, it’s not exactly cheap either. If you do find that your vehicle needs a new throttle body, you can expect to spend anywhere between $450 and $600 on both parts and labor.

Can I replace throttle body myself?

Disconnect any air or vacuum hoses from the throttle body. Remove the throttle position sensor from the throttle body. Remove the throttle body mounting screws and remove the throttle body assembly. Discard the old gasket and install a new gasket between the throttle body and manifold during installation.

How do I clean my throttle body?

Follow the plastic duct from the air filter housing up to the throttle body. Remove the duct and locate the throttle cables and rotating mechanism. Rotate the throttle mechanism and spray the cleaning solvent around the inside of the throttle body. Give it a moment to work and then wipe out the crud.

What does a throttle body spacer do?

The throttle body spacer is placed between the throttle body, which controls airflow into the engine, and the intake plenum. This increases the volume of the space between the intake runners and the throttle body, which gives more air to the engine.

What size is the throttle body on a 5.7 Hemi?

5.7L-6.1L-6.4L-SRT8 Hellcat-Trackhawk-Demon Hemi V8 Throttle Bodies

Order Engine Size MM Size
Click to ORDER 2005 – 2012 Hemi V8 801 Casting Standard Mod 86mm
Click to ORDER 2005 – 2012 Hemi V8 847 Casting Standard Mod 86mm
Click to ORDER 2013 to Present Hemi V8 251 Casting Standard Mod 86mm

How many hours does it take to replace a throttle body?

How long does a throttle body replacement take? The job usually takes around an hour for either a replacement or a cleaning.

Can throttle control make car not start?

The throttle body plays a vital role in regulating the amount of air that goes into your engine. When it goes bad, your car may not even start. It’s important to identify a bad throttle body quickly so you can have it fixed as soon as possible.

Can I drive with electronic throttle control light on?

It is not safe to drive with an electronic throttle control light. While you might be lucky and only have a drop in fuel efficiency or a slight drop in acceleration, the problem can quickly get worse if the sensor readings continue to go awry.

What are the symptoms of a faulty throttle body?

7 Symptoms of a Bad or Failing Throttle Body

  • Lack of Power. …
  • Issues while accelerating. …
  • Higher or Lower Idling. …
  • Dirt or Grime Build-up. …
  • Poor Mileage. …
  • Electrical Problems. …
  • Check Engine Light.

How do you know when your throttle body is going bad?

When the throttle body gets dirty, it has a direct effect on how smoothly the engine operates. Signs indicating a problem include rough idling, jumpy or sluggish acceleration, poor fuel economy, and stalling. With the use of a throttle body cleaning product, the dirt and debris buildup are easily removed.

What can cause a throttle body to go bad?

One of the main causes of a malfunctioning throttle body is internal contamination. Due to the contamination accumulated in the throttle body, the throttle valve can no longer move properly, causing problems with the control of the air supply.

Can throttle body cause transmission problems?

The Throttle Position sensor measures the throttle position, which is controlled by the gas pedal. It is used to determine engine load and if it fails it can cause automatic transmission shifting problems.

What do you need to change a throttle body?

The air duct to the throttle body is usually held in place with some type of hose clamp, which can be loosened with a screwdriver, Torx-head wrench, Allen wrench or other hand tool. Sometimes the air duct is pressed into place and can be removed with some gentle twist and pull movements.

When should a throttle body be installed?

Replacing a Throttle Body

  1. Remove the Hose from the Throttle Body. Making sure that your engine is turned off, open the bonnet and locate the air filter case. …
  2. Detach the Air Cleaner. …
  3. Deactivate Air Control and Throttle Position. …
  4. Remove Throttle Cables. …
  5. Unbolt the Throttle Body. …
  6. Install the New Throttle Body.

Does a throttle body need a gasket?

The throttle body gasket is gasket made of paper or aluminum that is sandwiched between the throttle body and the intake manifold. Its purpose is to provide an air tight seal between these components so that incoming air can not bypass the throttle body. This gasket is often replaced during a throttle body service.