Skip to content

Where is the fuel pump control module located on a 2013 chevy malibu?

The 2013 Chevy Malibu fuel pump control module location is on the right side of the luggage compartment, under the carpet. Having the fuel burn efficiently is the key to maximizing Your miles per gallon.

Where is the fuel pump control module located?

The module is typically installed on or very close to the fuel pump, and in the early years of the component’s use, this practice led to a design fault. Manufacturers, including Ford, initially placed the module inside the vehicle immediately above the fuel pump, typically just beneath the floor pan.

Where is the fuel pump control module located on a 2014 Chevy Malibu?

The module is typically installed on or very close to the fuel pump, and in the early years of the component’s use, this practice led to a design fault. Manufacturers, including Ford, initially placed the module inside the vehicle immediately above the fuel pump, typically just beneath the floor pan.

Where is the fuel pump module located on a 2018 Chevy Malibu?

You should find the fuel pump power control module in the trunk on the passenger side.

Where is the fuel pump relay on a Chevy Malibu?

The 2013 Chevy Malibu fuel pump relay is located in the fuse box. To get to the fuse box look to the left of the steering wheel look for a small seam or crack along the dash. Using a screwdriver or prybar You will want to pop this open. On the inside, You will find a bunch of fuses.

How much does it cost to replace a fuel pump module?

The average cost for a fuel pump replacement is between $220 and $1,062, depending on vehicle and age. Labor costs are estimated between $124 and $260, while parts are priced between $95 and $854. Estimates do not include taxes and fees.

How do you reset a fuel pump control module?

The fuel pump shut-off switch has a red reset button on top of it.

Should your vehicle shut off after a crash, you may restart your vehicle:

  1. Switch off the ignition.
  2. Switch to start position.
  3. Switch off the ignition.
  4. Switch on the ignition to re-enable the fuel pump.
  5. If vehicle does not start, repeat steps 1 through 4.

What is fuel pump control module?

The Fuel Pump Driver Module controls the voltage delivered to a vehicle’s fuel pump. By controlling the voltage, the module maintains optimal fuel pressure and fuel delivery to the engine throughout its full operating range.

What does code po69e mean?

Code P069E stands for Fuel Pump Control Module (FPCM) Requested MIL Illumination. The fuel pump control module (FPCM) is the computer that monitors the operation of the fuel system. It receives input regarding desired fuel pressure from the engine control module (ECM).

Where is the fuel pump on a 2015 Chevy Malibu?

Located inside your fuel tank, a fuel pump has a small electric motor to make sure that pressurized gasoline flows to the engine to power the vehicle.

Where is the fuel pump on a 2016 Chevy Malibu?

On most vehicles, the fuel pump is located inside the fuel tank. To replace it – depending on the vehicle – either remove the cover from a designated opening above the fuel tank or remove the fuel tank. When replacing the fuel pump, it’s common to also replace the fuel filter.

Where is the fuel pump relay located on a 2016 Malibu?

It is located on the driver’s side of the instrument panel, behind the cover to the left of the steering wheel.

Where is the fuel filter located on a 2015 Chevy Malibu?

The fuel filter is always going to be found between the fuel tank and the engine. For most vehicles, the fuel filter is located inside the top of the fuel tank, right where it connects with the fuel line, although on some cars if might be elsewhere along the fuel line.

Where is the fuel pump relay on a 2013 Chevy Malibu?

It is located on the right side of the luggage compartment. It is under the carpet.

Where is the fuel pump located on a 2012 Chevy Malibu?

it’s in the fuel tank. pricey also,around $300.00-$500.00 if you buy it and you put it in.

Where is the fuel pump fuse on a 2010 Chevy Malibu?

Fuse box location

It is located on the passenger side of the vehicle, on the lower portion of the instrument panel near the floor, behind the cover.

Does AutoZone replace fuel filters?

When your fuel filter starts to deteriorate, your fuel system can get dirty, so it’s important to change it out before bigger problems happen. If it’s time for a gas filter replacement, AutoZone has everything to get the job done.

What is a fuel pump module assembly?

The fuel pump module assembly is mounted in the fuel tank and includes the electric fuel pump, fuel strainer and fuel gauge sending unit. No or low fuel pressure may be caused by a faulty pump, which would in turn cause a no-start condition or misfiring and surging.

Can AutoZone check fuel pump?

If your car is running rougher or using gas less efficiently, it may be time for a fuel pressure test. AutoZone makes checking fuel pressure easier than ever. Get a fuel pressure test kit and check the fuel pump and fuel system on your ride today.

How do I reset my Chevy ECM?

Turn the headlight switch to the “On” position to drain the ECM of any remaining power. Wait at least 10 minutes, then turn it back to the “Off” position. Replace the negative battery cable by reversing the previous steps. Tighten the nut until it feels secure, paying attention not to overtighten it.

Can you bypass fuel pump driver module?

Re: Bypass Fuel Pump Module

It will work perfectly when completely bypassed because the PCM is no longer included in the fuel pump power supply circuit. You are literally ‘hot wiring’ power from the fuel pump fuse, through the fuel pump relay, right to the fuel pump in the tank.

What is a fuel module?

The fuel module is a component of the fuel delivery system that manages the quantification and extraction of fuel inside the fuel tank present on every vehicle. Some vehicles have several fuel modules in their fuel tanks.